EMSER Inhalation solution, 2X60 pcs

Instructions for use for EMSER Inhalation solution, 2X60 pcs

Detailed instructions for EMSER Inhalation solution, 2X60 pcs

Field of use

Emser Inhalation solution ISOTON (pack size: 2x60 pc) is a germ -free solution of natural Emser salt in a concentration that corresponds to the mineral content of the blood (isoton) for inhalation with a suitable Electrical inhalation device (such as nozzle or compressed air nebulizers, ultrasound nebulizers or swing membrane abrasions).

Application areas:

• with dry mucous membrane
• in diseases that are accompanied by increased mucus formation and mucus retention, such as acute and chronic bronchitis, chronic obstructive bronchitis, asthma bronchial, cystic fibrosis etc.

Active ingredients / ingredients / ingredients

Emser Inhalation solution isotone (pack size: 2x60 pc) contains:

100 ml solution contain 1.175 g Natural Emser Salt, cleaned water

Contradictions

In the case of known hypersensitivity to one of the above -mentioned ingredients, this product should not be used.

dosage

Application recommendation of Emser Inhalation solution isotone (pack size: 2x60 pc):

The following information applies unless your doctor Emser® inhalation solution has not prescribed otherwise.
Please adhere to the application regulations, since Emser® inhalation solution cannot otherwise work properly!

Emser® inhalation solution should be inhaled 3 to 4 times a day, whereby 5 ml solution should be inhaled with each inhalation. The inhalation should always be carried out with a suitable atomy. Electrical nebulizers (ultrasound nebulizers, nozzle or Compressed air mutoma or swing membrane abraded). Depending on the device type, the volume, which must be used for atomization, can vary greatly. In this case, so much solution should be filled into the inhalation device that an inhalation period of 10 to 15 minutes is guaranteed.
If Emser® inhalation solution is used as a carrier solution for other inhalation solutions such as beta-sympathomimetics and anticholinergics, the dilution regulation of the corresponding manufacturers should be observed. As a rule, these medicines should be mixed with 2-5 ml Emser® inhalation solution.
Attention: Mixtures must be made fresh before each inhalation and must not be kept. The duration of the use of Emser® Inhalation solution is not limited, but a break of at least 2 hours must be observed between the individual applications.
Please stick to your doctor's instructions.

Hints

Manufacturer:  Sidroga Society for Gesundh, Arzbacher Straße 78, 56130 Bad Ems